The Chroma Power Supply Automatic Test system Model 8000 is the ultimate solution for power electronic testing. The system includes a wide range of hardware choice such as AC/DC Sources, Electronic Loads, DMM, Oscillate Scope, Noise Analyzer and OVP/Short Tester. This flexibility combined with its open architecture software platform PowerPro III, gives users a flexible, powerful and cost effective test system for almost all types of power supply testing.

8000 Model Switching Power Supply ATS

• Open architecture software platforms
• Test command optimizer helps to improve test speed
• Capable of testing almost any power supply or related device
• Comprehensive hardware modules provide high accuracy and repetitive measurements
• High test throughput by system default test items
• Microsoft Word based evaluation report or UUT characterization
• Cost effective
• Other hardware expandable upon request
• Windows 98/2000/XP based software

Comprehensive Test Items

The Model 8000 automatic power supply test system comes standard with an off-the-shelf test item library covering most industry standard power supply tests. Unlike traditional ATE software, users do not need to have programming language background to create new test items. Instead the Model 8000 allow users to use pre-compiled test items and to simplify defining test conditions and specifications.

The comprehensive test items cover 7 categories of power supply testing requirements. OUTPUT PERFORMANCE checks the general performances of the UUT. INPUT CHARACTERISTIC verifies the input parameters of a power supply. REGULATION tests the stability of the UUT under varying line-in and loading changes. TIMING AND TRANSIENT measures the transient state during turn-on, turn-off or when events occurred. PROTECTION TESTS triggers the protection circuit of the power supply. Finally, the SPECIAL TEST and the SPECIAL FEATURES provides means to test the most sophisticated power supplies when unique test routines are needed.

Output Performances 1. DC Output Voltage 2. DC Output Current 3. Peak-Peak Noise 4. RMS Noise 5. Current Ripple* 6. Efficiency 7. In-Test Adjustment 8. Power Good Signal 9. Power Fail Signal 10. P/S ON Signal 11. Extended Measure 12. Waveform Capture 13. Overshoot Voltage Input Characteristics 14. Input Inrush Current 15. Input RMS Current 16. Input Peak Current 17. Input Power 18. Current Harmonics Against Regulations 19. Input Power Factor 20. Input Voltage Ramp 21. Input Frequency Ramp 22. AC Cycle Drop Out 23. PLD Simulation

Regulation Tests 24. Current Regulation 25. Voltage Regulation 26. Total Regulation Timing & Transient 27. Power Up Sequence 28. Power Down Sequence 29. Transient Response Time 30. Transient Spike 31. Turn On Time 32. Rise Time 33. Fall Time 34. Hold-Up Time 35. Extra Timing 36. Tracking 37. Swing Check Protection Tests 38. Short Circuit 39. OV Protection 40. UV Protection 41. OL Protection 42. OP Protection

Special Tests 43. Fan Speed 44. Auto-Alignment* 45. Correlation Test 46. UUT Measurement Verification Test 47. High DI/DT Loading Special Features 48. Can Bus Read/Write 49. IC Read/Write* 50. GPIB Read/Write 51. RS-232 Read/Write 52. RS-485 Read/Write* 53. TTL Signal Control 54. Relay Control 55. Bar Code Scan* 56. DMM Mode

* These test items need to be created by users by using test item editor due to the variety of the UUTs. And unlimited customized or user defined test items are allowed.

New Millennium ATS Software Platform

The Model 8000 Test Systems include the industries most sophisticated power supply testing software platform, PowerPro III. PowerPro III provides users with an open software architecture suited for a wide range of applications and devices.

More on PowerPro 3

Model	Description	Quote	Buy
8000	Automated Test Systems		Call